5 Ton Rockwell Hubs - 800 Series

5 Ton Rockwell Hubs - 800 Series Product Description:

(TAKE OFF - AS IS) WITH OR WITHOUT STUDS AND NO BEARING RACES

THESE ARE 100 LBS EACH WITH RACES AND STUDS

800 SERIES FRONT OR REAR AXLE (THESE ARE THE SAME HUB)

THESE CAN BE USED ON ANY 800 OR 900 SERIES AXLES FRONT OR REAR, FLIPPED EITHER WAY

THIS HUB ONLY HAS 10 DRIVE FLANGE/ AXLE SHAFT BOLT HOLES ON BOTH SIDES OF THE HUB

FLIPPED INWARD NARROWS AXLE WHEEL FLANGE MEASUREMENT BY 8 INCHES PER SIDE (NO MACHINE WORK NEEDED)

FLIPPED OUTWARD WIDENS AXLE WHEEL FLANGE MEASUREMENT BY 8 INCHES PER SIDE

16 INCH TOTAL DIFFERENCE DEPENDING ON DIRECTION OF HUB PLACEMENT 

** NOTE** -  THESE WERE USED ON THE 900 A1 SERIES STRAIGHT REAR AXLE FROM THE FACTORY